|
|
|
RE.8 Gallery
Front cockpit
Points of note:
-
Morse Key mounted on the right of the instrument panel
-
Flying controls
Points of note.
Evolution of the Interrupter Gear fitted to the RE8
The Vickers system used mechanical linkage, while the Constantinesco was a hydraulic system.
Image courtesy of Aero Illustration
Wood components fabricated from original RAF drawings.
Aft section of fuselage being laid out
Mid fuselage section trial fit prior to varnishing and painting metal fittings
Parts begining to look like an airplane fuselage
Checking fit of complex fuselage fittings
Detail of forward lower crossmember and fittings
Ash lower longerons and mid fuselage metal fittings installed to begin fuselage assembly.
Mid fuselage section nearly complete with pilots seat bearers installed.
Detail of forward lower fittings after painting and installation of hardware.
Ash engine bearers installed on fuselage section
Engine bearer bracketry installed and aft fuselage structure added. This nearly completes the entire fuselage.
Murray Hunter completing wire bracing and truing up fuselage.
Landing gear and flying wire fitting detail
Fuselage assembly details
Gene DeMarco applying PC10 color to linen fabric note fabric details and lacing to allow the covering to be removed or opened
Attaching fabric to fuselage longerons
Graham Gilliver applying reinforcing tapes
Brett Larsen adding the Bristish roundels to the underside of the wing
Plywood Turtledeck installed and tailskid assembly completed. Internal wire bracing installed and Vickers gun mount added.
Detail of Vickers gun mount floor installed trial fit empennage.
Cabane struts fuel tank and center section installed.
Center section detail linen covering applied.
Chris Higson trueing up tailgroup
Assembled airframe on workshop floor
First test fit of lower wing panel.
RE8 fuselage covered and ready for engine bearers to be installed, note oil tank
Replica Vickers Gun mount detail
Replica Lewis guns installed on dual yoke Scarff ring mount complete with Norman vane sight
Step and covering Detail, note bomb aiming sight
Finishing details being applied SE.5a in background
Nearly complete aircraft engine being installed exhaust system being fabricated.
Engine cowlings fabricated and prop installed.
Pilots area details showing hand air pump ammo box control stick and constantinesco pump.
Cockpit detail showing elevator trim wheel wicker seat reproduction ammo box leather seat cushion constantinesco gear pump a
View looking aft inside fuselage showing wire bracing linen covering and gunners seat.
The RE8's size is very impressive
Completed aircraft not instrument details cockpit plumbing aldis sight bomb sight and replica Lewis gun.
Cockpit detail and gunner in position
War-weary Re8 being serviced
On display at the Aviation Heritage Centre Omaka
|
|
|