|
|
|
Cable Splicing
The splice after hammering on the fourth tuck The completed splice ready for service Cutting the tails to finish the splice The splice after all tucks are completed and tails cut off Showing the fully served splice and pulling the tail of the thread inside the serve The first tuck of the splice is completed The last stage of the splice showing the half tuck Beating the splice with an ash mallet to tighten it further. The second tuck of the splice showing a tail protruding between each wire Starting to serve the splice with waxed linen thread The first step of the splice showing the tails soldered and the thimble held in place. The splice after the third tuck prior to hammering Threading the first wire of the splice Pulling the first tuck of the splice tight
|
|
|
